- Expose the area that is to be sealed. Clean the entire area around the joint with a wire brush and whisk broom.
Remove any sharp protruding edges around the joint with an abrasive tool. When finished cleaning, the entire area must
be dry and free of any dirt.
|
 |
- Remove the first foot of paper backing from the mastic. Center and place the Gator Wrap around the joint. Continue to
remove paper backing as you apply the Gator Wrap to the entire structure.
|
 |
- Seal the overlapping area with a 6” overlap. Be sure not to stretch material at the overlap area.
|
 |
- Cut excess material using a utility knife. Using a rubber mallet or hand held roller, firmly flatten the Gator
Wrap 360 degrees around joint.
|
 |
